Step By Step Guide On Making A CD Case For D+T Resistant Materials Essay Example for Free

Step By Step Guide On Making A CD Case For D+T Resistant Materials Essay1. Find unspoiled equipment ruler, chisel, sense paper, glue, pine and ply2. Measure the right lengths of wood and then cut into 4 appropriate parts 250mm for the lengths and 170mm for the widthsEquipment needed Ruler, saw, pencil3. Create a rectangle for the main frame-using lap joints (250mm tall and 170mm in width, sand if needed),4. Equipment needed chisel, hammer, glue and pencil5. Create long thin pine ab appear 95mm long and 7mm high (so they look a bit like sticks) make about 12 pieces (6 ether side) to make the backup for the CDsEquipment needed pencil, saw, ruler6. Glue the pine sticks to the inside of the frame making sure that nothing sticks out using sand paper, and also making sure that it only goes about 3/4 of the flair down to leave space for the storage area.Equipment needed glue, sand paper7. Before sticking on the plyboard make sure the CDs fit in between the frame nicelyEquipment nee ded CD8. Making sure that nothing is sticking out and that the measurements are all correct glue the plywood on to the back of the pine frame.Equipment needed ruler, glue9. Sand down any sticking out bits to make it look presentable.Equipment needed sand paper10. Sand the corners to make it aesthetically pleasing as possible.Equipment needed sand paper11. Then for a finishing touch add water base vanish.Equipment needed vanish